Buyer's guide
Prop strike in the logbook: what it means when you buy an aircraft, and what to ask
Published 16 November 2026.
"Prop strike" is one of the entries that makes buyers hesitate. It does not have to end a deal, but it changes what you need to see before you sign. Below is how the engine manufacturers define a propeller strike, what they require before the engine flies again, what the aviation authorities say about it, and the documents we ask the seller for. The engine-specific rules quoted here are Lycoming's and Continental's; for other engines, the manufacturer's own instructions apply.
What counts as a propeller strike
The definition is wider than most people think. Lycoming's Service Bulletin 533D, of 10 February 2026, says a propeller strike includes:1
- any incident, with the engine running or not, where the propeller needs repair;
- any impact of the propeller on a solid object while the engine is running, ground included, even if the propeller keeps turning;
- a sudden drop in RPM on impact with water, tall grass or a similar yielding surface, even when the propeller is not usually damaged;
- for helicopters, a rotor strike while the engine is coupled to the gearbox.
The bulletin adds cases that happen at taxi speed, during touch-and-go with a blade tip touching the ground, on a stationary aircraft whose landing gear collapses, or when a hangar door hits a blade.1 Continental's bulletin on the same subject, SB96-11B, defines propeller strike and propeller foreign object damage, and covers hydraulic lock in the same document.3
What the engine manufacturers require
Lycoming's bulletin is classed as mandatory, applies to all Lycoming reciprocating engines and sets the time of compliance as "before further flight".1 Its reasoning is the part buyers should read:
- the circumstances of a strike do not predict how much the engine was damaged;
- damage can be hidden at first and grow with time and wear;
- there is no clear threshold to measure the damage, so Lycoming's corrective action is a sequential checklist that starts with removing the propeller and the engine and disassembling it to inspect the crankshaft, camshaft, connecting rods, gears and the crankcase.1
Two more points from the same bulletin:
- A bent crankshaft propeller flange is replaced, never straightened or ground.1
- Responsibility. The organisation that returns the aircraft to service is responsible for the decision to operate an engine that had a propeller strike, and Lycoming says it does not take that responsibility.1 The completed checklist is kept as a service record and the results go in the engine logbook.
For Continental engines, the FAA's Special Airworthiness Information Bulletin NE-11-54 recommends the inspections of SB96-11B and the overhaul manual before returning the engine to service after a strike or hydraulic lock. The bulletin came after a propeller shaft failed on a Cessna 421 whose engine may have been returned to service after an earlier accident without that inspection.2 New Zealand's civil aviation authority issued a similar notice after a catastrophic engine failure likely linked to an earlier hydraulic lock.3
Both the FAA bulletin and the New Zealand notice are advisory, not airworthiness directives.23 In practice, a buyer, a lender or an insurer will ask whether the manufacturer's instructions were followed, and a "visual inspection only" entry is hard to defend at resale.
What a well-handled strike looks like in the records
This part is our reading as brokers. A strike handled properly leaves a trail:
- an entry describing the event: date, where, what was hit, engine running or not;
- the propeller's fate: repaired by a propeller shop under the propeller manufacturer's instructions, or replaced;
- the engine inspection: the manufacturer's checklist, or an overhaul, or a replacement engine with its own records;
- for a twin, which side, and confirmation that the engine mount and nacelle were checked;
- a release to service signed by the maintenance organisation.
Some cases end with less work than a teardown, others with a new engine. What matters is that the decision was taken by the people responsible for it and is written down.
An example from our inventory
The 2018 Diamond DA42-VI in Switzerland had its right engine and right propeller replaced in December 2025, at 456 hours, after what the seller reports as a propeller strike on a waterlogged grass surface. We state it on the listing because it is the first thing a careful buyer will find, and because the outcome was the cautious one: a new engine and propeller rather than an inspection and return to service. Before closing, the documents we ask for are the occurrence report, the damage assessment and the release to service after the replacement.
On a Lycoming-powered aircraft, such as the Piper Seminole or the Piper Archer, or a Continental one such as the Cessna 150M, the questions are the same, measured against the bulletins above.
What to ask the seller
- Has the aircraft ever had a propeller strike, sudden stoppage, hydraulic lock or gear-up landing? Ask in writing.
- If yes: the logbook entries, the propeller shop's report and the engine inspection checklist or overhaul records.
- Which engine manufacturer's instructions were applied, and who signed the return to service.
- Whether the insurer paid a claim, and the claim file if possible.
- During the pre-purchase inspection, ask the inspector to look specifically at the engine mount, the propeller flange and the logbooks around the date of the event. Our checking routine covers the rest.
Frequently asked questions
Is a prop strike a reason not to buy an aircraft?
Not by itself. It is a reason to see the file. A strike handled under the engine manufacturer's instructions, with the records, is a known history; a strike with no inspection on record is the risk.
Does hitting tall grass or water count?
For Lycoming, yes: a sudden RPM drop on impact with water, tall grass or a similar yielding surface is included in the definition, even without visible propeller damage.
Is the teardown inspection mandatory?
Lycoming classes its bulletin as mandatory, with compliance before further flight. The FAA and New Zealand notices on Continental engines are advisory but recommend the manufacturer's inspections. The organisation that returns the aircraft to service is responsible for the decision.
What about diesel engines and turboprops?
The bulletins quoted here cover Lycoming and Continental piston engines. For other engines, follow that engine manufacturer's instructions and ask the seller which ones were applied.
Sources
- Lycoming Engines, Mandatory Service Bulletin No. 533D, "Recommended Action for Sudden Engine Stoppage, Propeller/Rotor Strike or Loss of Propeller/Rotor Blade or Tip", 10 February 2026: lycoming.com
- FAA, Special Airworthiness Information Bulletin NE-11-54, "Propeller System", 8 September 2011 (copy on the EASA airworthiness directives site): ad.easa.europa.eu
- Civil Aviation Authority of New Zealand, Continuing Airworthiness Notice 85-003 Revision 1, "Teledyne Continental Engines – Propeller Strikes and Hydraulic Locks", 26 April 2019: aviation.govt.nz